Re: A/D board recomendation?

[inet@intellisys.net (brian whatcott)]

At 11:24 AM 4/15/97 -0400, kyle forinash wrote:
> Hi,
>
> Can anyone recomend an A/D board with the following capabilities:
>
> 1) Will work with a Mac (I've got access to many older models which are
> just laying around unused).
>
> 2) Has 3 channels to input data.
>
> 3) Can take data accurately at a rate of at least 200Hz on all three
> channels simultaneously and continuously.
>
> 4) Doesn't cost an arm and a leg.
>
> 5) Is not too difficult to control (ie. comes with good software or can be
> controlled with BASIC or something easy to program).
>
> I've been using Vernier's ULI, which is great and easy to use but only has
> 2 channels. Can anyone recomend the next step up?
>
> Thanks
> kyle
>
> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
> !  kyle forinash  

You might email Milan Podhorsky sorcerer@netcom.ca who
advertized several nubus boards used in excellent condition
yesterday on the sci.engr.control Newsgroup.

He mentioned
NB-MIO-16              National Instruments multifunction board.
 16 of 12 bit a/d
 2 of 12 bit d/a
 8 bits of i/o
 3 ctr/timers

Also NB-AO-6
SC-2072 etc.
1PB16HC

Regards
brian whatcott <inet@intellisys.net>
Altus OK