Re: test (ignore) AND Line break problem

[Dan MacIsaac <Dan.MacIsaac@NAU.EDU>]

On Tuesday, November 5, 2002, at 12:03 PM, David Bowman wrote:

> 12345678901234567890123456789012345678901234567890123456789012345678901
> 23456789012345678901234567890123456789012345678901234567890123456789012
> 34567890123456789012345678901234567890123456789012345678901234567890
>
> This posting is the position of the writer, not that of SUNY-BSC, NAU
> or the AAPT.
There is a test list called PHYS-TEST-L@lists.nau.edu for this sort of
experimentation; see
<http://mailgate1.nau.edu/archives/>
for further information and the archives of PHYS-TEST-L.

There are also ways of identifying settings for MIME-handling to
LISTSERV; directions are found on the
PHYS-L homepage.  Unfortunately, MIME settings for non-DIGEST mode
subscribers are only available
by emailing commands to listserv; the kinder, gentler web-based
LISTSERV control interface on the
archives pages only controls MIME settings for DIGEST mode subscribers.
 Eg:
<http://mailgate1.nau.edu/cgi-bin/wa?A1=ind0211&L=phys-l>
On the far RHS, the second-last icon shows a person joining or leaving
a group.  Clicking on that
icon allows the reset of MIME options for DIGEST subscribers only.

And I'm afraid that I don't know if either of these routes will fix
Mike's problem :^)

Best regards,

Dan M

Dan MacIsaac, Assistant Professor of Physics, SUNY-Buffalo State College
222SCIE BSC, 1300 Elmwood Ave , Buffalo NY 14222 USA 716-878-3802
macisadl@buffalostate.edu  http://PhysicsEd.BuffaloState.edu

This posting is the position of the writer, not that of SUNY-BSC, NAU or the AAPT.